![]() |

|
|
#1 |
|
Member
My Rig: 86 toyota
Join Date: May 2011
Location: From Nevada!!! Ft. Carson
Posts: 88
|
I'm doing ram assist .
I've never taken apart the steering box before and I'm not gonna lie I'm a little scared to take it apart. I've looked online and threads and post was wondering if any one else has done this or has advice . Or even has a tapped ifs box they would sell me .
__________________
Locked front & rear Original 70xxx miles 5.29 /duals /4.7 in rear case 37 mtr's beadlocks ram assist Truck was 2wd. !! Less and less sheet metal every time I touch it!!! Chromoly stuff in front axle . 'Merica!! |
|
|
|
|
|
#2 |
|
#1 Member
My Rig: 87 runner
Join Date: Apr 2007
Location: Colorado area
Posts: 2,741
|
There is a youtube video on it. That helped me a ton. I watched it like 3 times. The top hole is the one to be careful on. Start with the small drill bit and go easy. Make sure to flush it out really well! Jam a rag in the middle where the bearing are. You can do it. Just take your time.
__________________
87 runner on 42s "bad luck" |
|
|
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ARB Questions | TowerRigger | Mods & Cheap Tricks | 26 | 08-22-2007 08:02 PM |
| few pre SAC questions | tacoma87 | Solid Axle Swap Tech | 6 | 03-14-2007 01:18 PM |
| Old Man Emu questions | polska | Early Tacoma Tech | 25 | 12-17-2005 04:45 PM |
| dog questions | atwinda | Off Topic | 11 | 08-23-2005 04:31 PM |
| 2 low mod- questions? | TBob | Interior/Electrical/Electronics | 4 | 04-11-2005 10:02 PM |